Rack Assembly Instructions

Wall Racks Dimensions

Ski Wall Unit

Snowboard/Fat Skis Wall Unit

Parts Included

4 Spacer/washers

Additional Parts Needed

4 - 5/16 Mounting Bolts (NOT INCLUDED)

Recommended Outdoor Installation:

Use Galvanized 5/16 Lag Bolts

Installation Instructions:

Step 1 – Mark Wall From Ground at 40” (standard height)

Step 2 – Place Rack on Drawn Line (height of rack) and mark the 4 Drill Holes

Step 3 – Drill a pilot hole smaller than 5/16” in each bolt location

Step 4 – Place spacer/washer in rack with Lag Bolt and fasten to wall. If you are installing into concrete use anchor & bolts

Important: To ensure proper height for installation measure the longest pair of skis you will lock from tails to slightly above toe piece of binding. Use that measurement as the height for your rack installation from floor to bottom of locking rail.

NOTE: Our wall rack is designed to place the binding toe piece below the locking rails (See A illustration below). If you have older skis or skis with narrow binding plates your skis can be placed in the rack between the bindings and “hung” on the rack (See B illustration below).

SNOWBOARD WALL UNIT – Follow Ski Steps - Height can vary, insert Snowboard or Fat Skis between the bindings (See C & D,E Illustration Below)

Two snowboards can fit into one locking slot when placed bottom to bottom (Depending on thickness of Snowboard- See D Below)